Page 7 of 15
2013-2014 Research
Joint Test 19 2014-01-03
Sensors Tested – Aether-Magnetic Sensor in Steel Shielded case. Caduceus Coil, (Sallur Coil), Unshielded, Phone Wire, 7 Cross Points, Vertical, 30 inch long X 2 inch diameter.
Circuit’s used – (Aether-Magnetic circuit: 2200 uF sensor series capacitor and dual 10 uF Long Time Constant output circuit.). Caduceus Coil Circuit, Long time Constant, dual 10 uF capacitor filter on output.
Aether-Magnetic Circuit \Circuits\amag121213.pdf
Caduceus Coil (Sallur Coil) Circuit current as of 2014-01-21
Duration of Test – 24 hours
Purpose of Test – To compare our Unshielded Phone Wire Caduceus coil and Shielded Aether-Magnetic, at each of our locations.
Findings – The Caduceus Coil trace follows the Aether-magnetic sensor trace in the overall daily cycle wave. This corresponds to our geographic positions with respect to the daily solar cycle. Many individual smaller spikes, also match between both sensors at the same location. Peter also found matches in spike activity, common to both of our locations.
Result Images
Both Locations - Aether-Magnetic Sensors
Both Locations - Phone Wire Caduceus (Sallur) Coil
All Aether-Magnetic Sensors - Matches Found by Peter
_____________________________________________________________________________________
Unshielded Vertical Phone Wire 9 Cross Point Caduceus Coil Sensor Tests
Tony Devencenzi 2014-01-11 to 2014-01-12
Sensors Tested – Vertical Mounted, Unshielded, Caduceus Coil (30 inch long, 9 Cross Points (each Side), Caduceus wound of 6 Conductor Phone Wire, One Layer each direction. 2 inches diameter. (This coil was Brian Sallur's last design). Note: All 6 ends of individual wires at each end of the cable, are connected together. / Aether-Magnetic Sensor with standard 50VA transformer. (Aether-Mag sensor is shielded).
Circuit’s used – (Caduceus Coil Circuit with 1000 uF capacitor in series with Cad Coil. Long Time Constant output filter circuit, with two 10 uF capacitors. / Aether-Magnetic circuit: 2200 uF sensor series capacitor and dual 10 uF Long Time Constant output circuit.)
Aether-Magnetic Circuit \Circuits\amag121213.pdf
Unshielded Vertical 30 Inch Long 9 Crosspoint Phone Wire Caduceus Coil and Circuit
Duration of Tests – Four 24 hour tests.
Purpose of Test – To see if the Phone Wire Caduceus Coil would work as well or better, with 9 crosspoints instead of 7 used in the previous test.
Findings – This comparison test shows that the 9 point configuration doesn't have as high a sensitivity, as does the original 7 point, that was suggested Brian Sallur.
Result Images
Aether-Magnetic Sensor / Unshield Vert. 6 Cond. Phone Wire Caduceus Coil 9 Crosspoints=E-W
Aether-Magnetic Sensor / Unshield Vert. 6 Cond. Phone Wire Caduceus Coil 9 Crosspoints=N-S
_____________________________________________________________________________________
Vertical Phone Wire Caduceus Coil (Sallur Coil)
7 / 9 / 15 Cross Point Tests
Peter Newton 2014-01-30 to 2014-02-05
Sensors Tested – Unshielded Phone Wire Caduceus Coil (Sallur Coil) Caduceus coil on one channel and an Aether-Magnetic Sensor on the other channel. In all tests, the Caduceus Coil Cross Points were positioned facing East-West. The Aether-Magnetic transformer's flat sides, were positioned facing East-West as well. Also used was an LM35 Temperature Sensor.
Circuit’s used – Caduceus Coil circuit and Aether-Magnetic sensor. Note this test setup uses a Dataq DI-148 Analog to Digital Converter and USB interface device. The software, is Windaq Chart Recorder, which is included with the Dataq device.
Caduceus Coil Circuit (Unshielded, Phone Wire, 6 Conductor, Vertical)
Aether-Magnetic Circuit \Circuits\amag121213.pdf
Duration of Test – 24 hours
Purpose of Test – To record activity detected by the caduceus coil and compare with Aether-Magnetic sensor's trace.
Findings – Caduceus Coil tracks the Aether-Magnetic wave in general and with spike activity matches as well. There is some tracking of the Caduceus Coil's overall wave, as well as the Aether-Magnetic, to the temperature fluxuations as indicated by the LM35 temperature sensor.
It is also possible that when solar output is greater in terms of heat, that magnetic energies, may be higher at that time as well. It seems clear, that the 7 Cross Point Phone Wire Caduceus Coils has higher output than 9 or 15 Cross Point coils.
Result Images
7 Cross Point Phone Wire Caduceus Coil Photo
9 and 15 Cross Point Phone Wire Caduceus Coil Photo
15 Cross Point Phone Wire Caduceus Coil Photo
Phone Wire 9 Cross Points Caduceus Coil / Aether-Magnetic Sensor / Temperature sensor
Phone Wire 7 Cross Points Caduceus Coil / Aether-Magnetic Sensor / Temperature sensor
Phone Wire 9 Cross Points Caduceus Coil / Aether-Magnetic Sensor / Temperature sensor
Phone Wire 7 Cross Points Caduceus Coil / Aether-Magnetic Sensor / Temperature sensor
Phone Wire 15 and 9 Cross Points Caduceus Coil / Aether-Magnetic Sensor / Temperature sensor
